U.S. Marines Hitch Cover Plug 2 Inch Receiver TPU with Retaining Strap

Custom 3D printed by Got Items in Georgia, USA. Generic aftermarket accessory: not an official, licensed or OEM product.

U.S. Marines Hitch Cover Plug

Design

The U.S. Marines artwork from our larger U.S. Marines square hitch cover, in red and white, scaled to the plug face. The face is about 2.4 inches (62 mm) square.

Fit

Designed around a nominal 2-inch square hitch receiver opening. This flexible cap presses straight into the receiver and is held by press fit: two axial grip ribs on each outside wall (eight total) and four inner supports. An attached retaining strap (20 mm wide) with a square loop keeps the plug with the vehicle if it is knocked out: slip the loop over the receiver. Do not want the strap? Trim it off at the cap edge with scissors. No hitch pin is needed. Physical receiver fit and retention have not yet been confirmed; check your receiver before ordering. Decorative cover only: no towing or load-bearing function; remove before towing.

What is included

One U.S. Marines hitch cover plug with its attached retaining strap and loop. Vehicle, receiver and hitch pin are not included. Made to order.

Not made, sold, sponsored or endorsed by the U.S. Marines or the U.S. Department of Defense. The name and artwork are used only to describe the design.

Gallery images are digital product visualizations; actual printed texture and fine details may vary.