Florida State Seminoles Blackout Hitch Cover Plug 2 Inch Receiver Press Fit Cap

Custom 3D printed by Got Items in Georgia, USA. Generic aftermarket accessory: not an official, licensed or OEM product.

Florida State Seminoles Hitch Cover Plug

Design

The Florida State Seminoles artwork from our Florida State Seminoles blackout square hitch cover, in light gray on a black face, scaled to the plug face. The face is about 2.4 inches (62 mm) square.

Fit

Designed around a nominal 2-inch square hitch receiver opening. This flexible cap presses straight into the receiver and is held by press fit: two axial grip ribs on each outside wall (eight total) and four inner supports. No hitch pin is needed. Physical receiver fit and retention have not yet been confirmed; check your receiver before ordering. Decorative cover only: no towing or load-bearing function; remove before towing.

What is included

One Florida State Seminoles press-fit hitch cover plug. Vehicle, receiver and hitch pin are not included. Made to order.

Not made, sold, sponsored or endorsed by NCAA college athletics or the Florida State Seminoles. The name and artwork are used only to describe the design.

Gallery images are digital product visualizations; actual printed texture and fine details may vary.