Chicago Cubs MLB Blackout Hitch Cover Plug 2 Inch Receiver TPU Retaining Strap

Custom 3D printed by Got Items in Georgia, USA. Generic aftermarket accessory: not an official, licensed or OEM product.

Chicago Cubs Hitch Cover Plug

Design

The Chicago Cubs artwork from our Chicago Cubs blackout square hitch cover, in light gray on a black face, scaled to the plug face. The face is about 2.4 inches (62 mm) square.

Fit

Designed around a nominal 2-inch square hitch receiver opening. This flexible cap presses straight into the receiver and is held by press fit: two axial grip ribs on each outside wall (eight total) and four inner supports. An attached retaining strap (20 mm wide) with a square loop keeps the plug with the vehicle if it is knocked out: slip the loop over the receiver. Do not want the strap? Trim it off at the cap edge with scissors. No hitch pin is needed. Physical receiver fit and retention have not yet been confirmed; check your receiver before ordering. Decorative cover only: no towing or load-bearing function; remove before towing.

What is included

One Chicago Cubs hitch cover plug with its attached retaining strap and loop. Vehicle, receiver and hitch pin are not included. Made to order.

Not made, sold, sponsored or endorsed by Major League Baseball or the Chicago Cubs. The name and artwork are used only to describe the design.

Gallery images are digital product visualizations; actual printed texture and fine details may vary.